Minibus bus condition (light passenger vehicles 5-7 meters in length) typically uses non-independent air conditioning systems. Common layouts include roof-mounted (single evaporator) and split-type (two or more evaporators). The condenser is usually located in the side skirts and cooled by a separate electric condenser fan. The compressor uses a non-independent drive system, located to the left or right of the engine and directly driven by a drive belt.
The installation process for minibus bus condition involves mechanical, electrical, and refrigeration systems. It is strongly recommended that this be performed by a professional installation team. A professional team can ensure installation quality and avoid system malfunctions or safety hazards caused by improper operation. Chinese manufacturers have rapidly risen to prominence by leveraging their domestic bus manufacturing advantages; SONGZ and BUSCLIMA are typical examples.
The installation of Minibus Bus Condition is a highly technical process, involving several key aspects such as compressor mounting, pipe connections, electrical wiring, and system debugging. To ensure installation quality and long-term stable system operation, please visit www.busclima.com or contact busclima@kingclima.com
Installing a Minibus Bus Condition requires following a series of professional steps. Below is a general procedure:
Compressor Installation
Secure the compressor to the engine block, install the drive belt, and adjust the tensioner to the required position. Ensure the parallelism error between the crankshaft pulley and the compressor clutch pulley does not exceed the standard value. The compressor installation angle should be controlled below 15°.
Pipe Connections
Connect the refrigerant pipes, ensuring secure and well-sealed connections to prevent leaks. For pipes laid under the vehicle, use covers to prevent impact from flying debris and stones.
Electrical Wiring
Connect the relay box, control panel, compressor, and sensor wiring correctly according to the wiring diagram, ensuring good soldering and accurate wire dimensions and colors.
System Commissioning
After installation, commissioning is required. Check the Bus Condition cooling effect, noise level, and for any abnormal odors to ensure the system is functioning properly.
English 
Spanish